Washing machine repair video to fix a broken water pump. My washer broke, and I made a video of how to replace the water pump on your wash machine. If the washer is not draining, the water pump is probably broken. Water pumps on washing machines are not hard to fix, watch here and i'll show you how to fix your Kenmore, Maytag, Whirlpool Sears washing machine.
Front Loading Washing Machine Broke? It happens more often than you think. With several models, a coin can get stuck in the drain pump, and the coin wrecks the impeller. The impeller is the round thing that looks like a airplane propeller, it pushes the water through the machine.
Washing Machine Repair isn't always hard
This repair is usually easy to do. Make sure of the following:
- The washing machine is turned off and unplugged from the wall
- The water lines are turned off and disconnected.
- There is no wet laundry in the machine.
The washing machine pump, for most washers, is located in the lower part of the machine, and you access it from the bottom panel of the machine. You will tilt the machine on its back and work from the bottom of it. Take cell phone photos as you take the bottom access panel off, and put all the screws in a bowl or container. Keep a bucket handy, as there may be some water in the hoses and pump as you disconnect them.
Use a pliers to remove the hose clamps, you may also need a screwdriver, pay attention to how the clamps are situated on the hoses, and where each hose goes! You don't want to cross the hoses, or the washing machine repair you've just done wont work.
There will be a power cord of some sort, this is usually a plug with a locking tang that plugs into the pump. Carefully bend back the tang with a screwdriver and pull off the plug. Pay attention to how the plug came out so you can put the plug back in the right way.
Let me know how your repair went in the comments below, always good to hear from you:
Guy
Great DIY appliance repair.
Fagor FAS3612 washer dryer combo fan
Very nice video, very helpful !
Thanks
susan
Nice!
Moxley
Great video! Leaves me hope that I can find a new digital controller board for my Jenn-Air stove. The Home Depot guy, of course, wanted me to buy a new stove.
Myra
Great video! I have a Maytag too, and have always wondered, what is the name of the little tune that plays so happily announcing the end of the cycle?
Jim McMahon
Real nice video. I am now ordering my washer pump to do the same thing. Nice guy and like the dogs too.
Don
As usual my nephew does a great job by making a repair look easy.